41
FAQ
Can I program a button to execute more
than one command?
No, you can not. However, you can create a
macro to execute a sequence of commands (see
page 31).
How do I program source switching?
See “Programming device items” on page 24.
How can I edit, label or delete buttons on
home panels?
You can do this via the Device menu items. All
changes you make to these items are
automatically updated in the Home menu.
How do I reset the Remote controller?
Normally, you never have to reset the Remote
controller. However, if the Remote controller’s
display freezes or if you notice unusual behavior,
you might need to reset. You will not lose any
saved programmed commands or macros.
• Carefully press the reset button on the back of
the Remote controller with a paperclip or
sharp pencil. The remote controller restarts
and beeps to indicate it is ready for use.
How do I revert to the original
configuration?
Reverting to the original configuration restores
the remote controller’s devices and commands to
its state when you purchased it. This means that
all programming is lost permanently. Normally,
you never have to revert the Remote controller.
1. Touch and hold the Remote controller
icon for a few seconds.
The first setup panel appears.
2. Scroll to the second setup panel.
3. Tap the Revert button.
4. Tap Revert to confirm the action.
How do I calibrate the touchscreen?
The remote controller is calibrated when it leaves
the factory, so normally you do not have to
calibrate it yourself. It is possible that the remote
controller displays a message to calibrate the
touchscreen. If this message appears, do the
following:
1. Tap as close as possible the upper
left corner using a blunt tip of a
pencil.
2. Tap as close as possible the upper
right corner using a blunt tip of a
pencil.