Filter
Top Products
106 – ENGLISH
Using the REMOTE 2 terminal provided on the connection terminals of the main unit, it is possible to operate the
projector from a control panel etc. furnished in a distant location where infrared remote control signal cannot be
received.
Example of a control panel layout
Pin assignments and control
Be sure to short-circuit Pins # and - when controlling.
Note
When pin # and pin - are short-circuited, the following buttons on the projector's control panel and on the
remote control cannot be used.
POWER button, SHUTTER button
In addition, the RS-232C commands and network functions that correspond to these functions cannot be used
either.
When pin # and pin - are short-circuited and then any one of pins % to * is short-circuited to pin #, the
following buttons on the projector's control panel and on the remote control cannot be used.
POWER button, input selection buttons (RGB1, RGB2, DVI-D, AUX, VIDEO, S-VIDEO), SHUTTER button
In addition, the RS-232C commands and network functions that correspond to these functions cannot be used
either.
•
•
Remote terminal External control
Remote terminal/External control
STANDBY ON
LAMP
RGB1
RGB2
VIDEO
S-VIDEO
Projector set up in a meeting room Control panel located in a different room
DVI-D
Remote terminal External control
Remote terminal/External control
STANDBY ON
LAMP
RGB1
RGB2
VIDEO
S-VIDEO
Projector set up in a meeting room Control panel located in a different room
DVI-D
Names of terminals Open (H) Short (L)
#
GND GND
$
POWER OFF ON
%
RGB1 Other RGB1
&
RGB2 Other RGB2
(
VIDEO Other VIDEO
)
S-VIDEO Other S-VIDEO
*
DVI-D Other DVI-D
+
SHUTTER OFF ON
-
RST / SET
Controlled by
remote control
Controlled by
external contact
D-Sub 9-pin (female)
external appearance
Names of terminals Open (H) Short (L)
#
GND GND
$
POWER OFF ON
%
RGB1 Other RGB1
&
RGB2 Other RGB2
(
VIDEO Other VIDEO
)
S-VIDEO Other S-VIDEO
*
DVI-D Other DVI-D
+
SHUTTER OFF ON
-
RST / SET
Controlled by
remote control
Controlled by
external contact
D-Sub 9-pin (female)
external appearance
Using the Remote 2 terminal