Filter
Top Products
C662M-E (5/03) 13
CONNECTIONS
The steps and Figures 3 and 4 show how to connect the units to each other and to a network. A dedicated LAN of four or more
viewstations requires a minimum network of 100BaseT (100 Mbit/sec). Integration within an existing LAN/WAN requires a
network of 100BaseT (100 Mbit/sec).
1. Connect the viewstation to the recorder via an Ethernet switch. Use shielded network cables.
2. Connect a monitor, keyboard, and mouse to the viewstation.
3. Connect up to five 37-pin connectors to the recorder.
4. Connect cameras to the recorder.
5. Connect the storage units to the recorder. Refer to the IDE or SCSI Installation/Operation manual for more information.
6. Connect all power cords.
7. Turn on the storage units and let them run for at least one minute (the hard disk drives must spin through their warm-up
cycle).
8. Turn on the recorder and let it boot for at least 30 seconds.
9. Turn on the viewstation.