Filter
Top Products
C695M-B (11/03) 35
When using the IR remote controller, you must step through screen sets in a linear fashion: full-screen channels followed by the 2x2, 3x3,
and 4x4 sets (refer to Figure 22). Press the + button to advance through the channel sets (1x1, 2x2, 3x3, 4x4). Press the - button to step
backward through the channel sets (4x4, 3x3, 2x2, 1x1).
1-9
8-16
16
10
11
12
13
14
89
15
16
123
4
56
789
1234
5678
910 12
13
11
14 1615
13 14
15
16
9
10
11 12
1-4
5-8
9-12
13 - 16
5
6
7
8
12
3
4
+ AND - BUTTONS ON IR REMOTE CONTROLS MULTICHANNEL OPERATION
16
1
1
Figure 22. Stepping Through Screen Sets: IR Remote Control
Sequences
You can automate the process of displaying multiple channels and channel sets. Press the SEQ button to set up the sequence; “SEQ”
appears on the top right of the screen. Select the channels and screen formats in their proper order. To stop sequencing, press the SEQ
button again.
NOTE: To use sequencing, you must enable it in the RECORDER SETUP screen. You can also set the DWELL TIME, that is, how long each
screen is displayed before the next screen in the sequence appears. Dwell time is a global item and applies equally to all sequence types.
NOTE: Sequence only displays channels with active video.