Filter
Top Products
44 C4631M-A (8/10)
The SMTP server IP address, port number, user name, and password are optional settings. The DVR can send e-mail without using an SMTP
server or MTA (message transfer agent). In certain cases, e-mail should be forwarded to a SMTP server.
To set up the mail feature:
1. From the Network menu, click Mail.
2. Click the Notification box, and then select ON. The remaining boxes become available.
3. Click the remaining boxes to enter their settings.
4. Click SMTP Test to verify the SMTP server connection. A pass or fail message appears and a test e-mail message is sent to each e-mail
address. The “Test email sent successfully” message indicates a successful SMTP server configuration. Verify that each addressee
received the test e-mail message.
Figure 32. Test E-mail Message
5. Click OK, and then click Close.
EMERGENCY NOTIFICATION SETUP
The emergency notification feature notifies the designated computer when an event occurs. The Emergency Agent application must be running
on the computer when the event occurs. This event must be configured on the Notification menu. For information about configuring the
notification option, refer to Notification Setup on page 43.
The emergency notification and e-mail notification features operate independently. The Emergency Agent application is installed on the remote
client computer and is used to display and administer emergency reports. For information about setting up the e-mail feature, refer to Mail
Setup on page 43.
The unit allows you to configure the following emergency notification settings:
• Notification: Turns on and off the notification feature.
• IP Address/Port: The remote computer’s IP address and port. Supported characters include 0.0.0.0 to 255.255.255.255.
• SMTP Port No.: The default port is 9003. Supported values include 025 to 65535.
To set up emergency notification:
1. From the Network menu, click Emergency.
2. Click the Notification box, and then select ON. The remaining boxes become available.
3. Click the remaining boxes to enter their settings.
4. Click Close.
5. Click OK.