Pelco DX4104 DVR User Manual


 
46 C4631M-A (8/10)
NTP SETUP
The unit’s internal time can be synchronized with an external time source using the Network Time Protocol (NTP) Date/Time configuration option.
NTP: Sychronizes the DVR’s time. This feature must be set to ON before the NTP server is selected.
NOTE: If the NTP option is set to ON, the Date/Time option is unavailable.
Server: Allows you to select a public or private NTP server. The default setting is PUBLIC SERVER. If you select public, the DVR computes
the average time from five public servers: time.nist.gov, time-a.nist.gov, timeb. nist.gov, ntp.nasa.gov, and clock.isc.org.
Private Time Server: Allows you to enter the IP address of a private NTP server. Server must be set to PRIVATE SERVER before you can
enter an IP address.
Sync. interval: Specifies how often the DVR synchronizes with the NTP server: daily (1 DAY), weekly (1 WEEK), monthly (1 MONTH), or
hourly (1 HOUR). The default is 1 DAY.
NTP Test: Verifies network access to the NTP server.
To set up NTP:
1. From the System menu, click NTP.
2. To enter the NTP settings:
a. Click the NTP box, and then select ON. The remaining boxes become available.
b. Click the Server box, and select a setting. If you select ON, click the Private Time Server box, type an IP address, and then click OK.
c. Click the Sync. Interval box, and then select a setting.
d. Click NTP Test to verify your settings.
3. Click Close.
4. Click OK.
SOUND SETUP
The sound feature allows you to configure the DVR to issue an audible sound in response to the activation of a button, an event (alarm or motion),
and a system state.
Button: If set to ON, the system beeps whenever a front panel or remote control button is pressed.
Alarm: If set to ON, the system beeps about once per second until the alarm event is acknowledged.
Motion: If set to ON, the system beeps about once per second until the motion event is acknowledged.
System: If set to ON, the system beeps when any system action occurs.
To set up the sound:
1. From the System menu, click Sound.
2. Click the boxes to enter their settings.
3. Click Close.
4. Click OK.