Filter
Top Products
Recording
06
51
En
English
Tip
• Stations that use VPS/PDC typically include VPS/
PDC information in the teletext TV guide pages.
Please refer to these when setting your timer
recording.
Timer recording using the ShowView
programming system
This system makes programming timer recordings very
simple. Most TV guides publish ShowView programming
numbers with their program details. If you want to make
a timer recording of a program, you just input the
corresponding code. The date, start, stop and channel
settings are made automatically. All you have to do is tell
the recorder the recording mode, and whether it’s a
once-only recording or a regular recording.
1 Press SHOWVIEW to display the ShowView
program screen.
You can also access this screen from the Home Menu
(press
HOME MENU
, select
Timer Recording
, then
ShowView
).
• Use the number buttons to enter the ShowView
programming number. (To clear the last digit
entered, press
CLEAR
.)
• Press
REC MODE
to change the recording quality
(see also
Setting the picture quality/recording time
on
page 46). If Manual Recording is on, then you can
also select the
MN
setting.
• Use the
/
(cursor left/right) buttons to select the
Once
,
Daily
or
Weekly
recording option.
• Use the
and
buttons to switch VPS/PDC
On
or
Off
.
2 After making the settings, press ENTER.
The program details are shown at the bottom of the
screen for a few seconds then the screen is automatically
exited.
• If you haven’t set up the guide channels (or at least
the guide channel for the ShowView programming
number that you entered), the recorder will prompt
you to enter the channel number that the TV program
is showing on.
Tip
• You can check the timer program settings by
pressing
TIMER REC
to display the timer recording
screen.
ShowView programming with the power off
You can enter a ShowView programming number when
the recorder is in standby.
Important
• You can’t use this feature until you have set up the
guide channels. See
ShowView CH Setting
on page 79
• You can’t change the recording mode.
• You can’t program daily or weekly timer recordings.
ENTER
CLEAR
REC MODE
ì
to input
3 9 9 2 4
09
ShowView#
Rec Mode
Rec Times
ShowView
MN21
Once Daily
Weekly
REC MODE
to change
to change level
to change
VPS/PDC
Off
to change
ENTER
CLEAR
PREV NEXT
ì
DVR-03_EU.book 51 ページ ２００３年７月２８日 月曜日 午後７時１９分