Pioneer DVR-3100 DVD Recorder User Manual


 
Additional information
13
98
En
On-screen displays and recorder displays
The table below shows a list of error messages that you may encounter when using the recorder and an explanation
of their meaning.
Message
Explanation/Action
• Initializing disc. Please wait a moment.
When you load a blank DVD-RW disc, the recorder automatically
initializes it.
• Incompatible region number.
The disc loaded has an incompatible region number for the
recorder and so will not play.
• Cannot record any more titles.
• No more space for file management data.
• Cannot add any more chapter marks.
The disc control data limit has been reached, or the maximum
number of chapters and/or titles has been reached. Erase titles/
chapters or combine chapters.
• This disc cannot be recorded. Undo the final-
ization.
The disc was finalized on a non-Pioneer DVD recorder. Undo the
finalization in order to recording/editing.
• Cannot play this disc.
• This disc cannot be recorded.
• Cannot read the CPRM information.
• Could not record the information to the disc.
• Cannot edit.
• Could not initialize disc.
• Could not complete finalization successfully.
• Could not undo finalization successfully.
• Could not successfully unlock the disc.
The disc may be dirty or damaged. Take out the disc, clean it and
retry. If the error persists, use a new disc. If the error appears even
with a new disc, please consult a Pioneer Service Center.
• Cannot record to a disc that is not CPRM com-
patible.
• Cannot record this content using Video mode
recording.
The video source is copy-once protected. Use a VR mode DVD-RW
disc with CPRM for recording.
• This content is copy protected.
The video source is copy-protected and cannot be recorded.
• Incorrect CPRM information.
The recorder could not read the CPRM information. The recorder
may be damaged—please consult a Pioneer Service Center.
• No DV input.
• Cannot preview because there is no DV input.
No signal was detected at the DV input/output jack. This may
appear if a blank section of DV tape is playing in the connected
camcorder.
• The audio will conform to the [Bilingual
Recording] setting.
When recording from an external input in Video mode, or in VR
mode set to MN 32, audio is recorded in Linear PCM format. You
can only record the left or right channel; not both.
• Repairing disc.
During recording, the power was cut. This display appears when
the power is restored.
• Could not repair the disc.
The recorder was unable to repair the disc after a power cut. The
contents of the recording will be lost.
• Playback has stopped because the TV system is
different than the recording.
During recording or timer recording standby, the Line System of
the playback video changed, causing playback to stop
automatically.
DVR-03_EU.book 98 ページ 2003年7月28日 月曜日 午後7時19分