Recording
06
52
En
1 Press SHOWVIEW.
The front panel display shows the current recording
mode and prompts you to enter the ShowView
programming number.
2 Use the number buttons to enter the ShowView
programming number.
• To clear the last digit entered, press
CLEAR
.
• Use the
PREV
/
NEXT
button to switch VPS/
PDC on/off. With VPS/PDC on, the front panel VPS/
PDC indicator lights. (Note that a maximum of 8
timer recordings can be set with VPS/PDC on.)
3 Press ENTER.
The display shows the timer settings:
Date
Start time
End time
Recording channel.
• If
CODE ERROR
appears in the display, check that
the ShowView programming number is correct and
start again from step
1
.
• If
CAN’T SET
appears in the display, it means that
although you entered a valid ShowView
programming number, the program has already
finished.
Stopping or extending a timer recording in
progress
After a timer recording has started, you can cancel or
extend recording.
1 Press and hold
ì
REC for 3 seconds.
Only the program is canceled (the timer indicator
disappears); recording continues.
2 If you want to stop recording completely, press
STOP REC.
• To extend recording, press
ì
REC
repeatedly to
extend recording in 30 minute increments.
Preventing use of the recorder before a
timer recording (child lock)
You can make all the front panel and remote control
buttons inoperative using the child lock feature. This is
useful when you set a timer recording and want to make
sure that the timer settings are not changed before
recording has finished.
1 If the recorder is on, switch it into standby.
2 Press and hold
STOP on the front panel for 3
seconds to lock the controls.
The front panel display briefly shows
LOCK
. If any buttons
are pressed on the remote or front panel,
LOCK
is briefly
displayed again.
• To unlock the recorder, press and hold
STOP
on
the front panel for 3 seconds.
• To cancel a timer recording when the recorder is
locked, first unlock the recorder (see above), then
press and hold
ì
REC
for 3 seconds.
Timer recording FAQ
Frequently Asked Questions
• Even though the timer is set, the recorder doesn’t start
recording!
Check that the disc loaded is recordable, not locked
(see
Lock Disc
on page 70), and that there are fewer
than 99 titles already on the DVD.
• The recorder won’t let me enter a timer program! Why
not?
You can’t enter a timer program while a timer
recording is in progress, during timer recording
standby or when the clock isn’t set.
• What happens when two or more timer programs
overlap?
Basically, the program with the earlier recording start
time has priority. However, the recorder will start
recording the program with the later start time after
the earlier program is finished. If two programs have
the same times (but different channels, for example),
the program set most recently takes priority.
If VPS/PDC is active for two timer programs that are
programmed to start at the same time, then the
program that actually starts first takes priority.
SHOWVIEW
29324
REC STOP REC
ì
DVR-03_EU.book 52 ページ 2003年7月28日 月曜日 午後7時19分