Pioneer DVR-3100 DVD Recorder User Manual


 
Recording
06
54
En
4 Press
ì
REC when you’re ready to start
recording.
The recorder will only start recording from the
DV IN/
OUT
jack if there is a valid signal. Recording will also
pause if the signal is interrupted during recording.
Note
If your source is copy-protected using CopyGuard,
you will not be able to record it. See
Restrictions on
video recording
on page 45 for more details.
Automatic recording from a satellite
tuner
If you have a satellite tuner or some other kind of set top
box connected to the
L3
input, you can have the recorder
start and stop recording automatically with the timer
settings of the connected component. (If the other
component doesn’t have a built-in timer, you’ll need to
use it with an external timer unit.)
After setting up for Auto Start Recording, this recorder
starts recording when it detects a signal from the other
component. When the signal ceases, the recorder stops
recording.
Important
It takes a little while for this recorder to switch on and
start recording after detecting a signal. Please bear
this in mind when setting the timer.
1 Set the timer for the satellite receiver (or other
component), then switch it into standby (if
necessary).
Check the manual that came with the receiver if you’re
not sure how to do this.
2 Load a recordable disc into this recorder.
3 Check that the ‘Audio In’ settings for ‘External
Audio’ and ‘Bilingual Recording’ are as you want
them.
See
Audio In settings
on page 81 for more on these
settings.
4 Set up the recorder.
Use
REC MODE
to set the recording quality. See
Setting the picture quality/recording time
on page 46
for detailed information.
5 Press and hold the FUNCTION button on the front
panel for 3 seconds.
The recorder goes into standby and the
AUTO
indicator
in the front panel display lights.
The recorder will automatically switch on and start
recording when the other component comes on.
Recording stops when the external component switches
off.
To cancel Auto Start Recording, press
STANDBY/
ON
. The indicator goes off.
To cancel Auto Start Recording once recording has
already started, press
ì
REC
for 3 seconds, then
STOP REC
.
Note
You can’t set Auto Start Recording when:
• the recorder is recording or in timer recording
standby.
• there is no recordable disc loaded.
• the disc loaded is locked.
• the disc loaded already contains the maximum
number of titles (99).
• If Auto Start Recording is set, it will not start if
another timer recording is in progress.
• Timer recordings take precedence over Auto Start
Recording. Auto Start Recording will stop if a timer
recording is due to start. After the timer recording
has finished, Auto Start Recording will resume.
Recording from a DV camcorder
You can record from a DV camcorder connected to the
DV IN/OUT
jack on the front panel of this recorder. Using
the recorder’s remote, you can control both the
camcorder and this recorder.
Before recording, make sure that the audio input for the
DV IN/OUT
jack is setup (see
DV Input
on page 82).
VR mode Video mode
VR mode Video mode
RETURN
HOME
MENU
ENTER
CLEAR
PAUSE STOP
REV SCAN PLAY FWD SCAN
STEP/SLOW
REC MODE
ì
DVR-03_EU.book 54 ページ 2003年7月28日 月曜日 午後7時19分