Filter
Top Products
34 35
Wireless - Manual
If you have a static IP address or the Automatic procedure does not work, you'll
need to set the Network Settings values manually.
1.
Follow the directions in Wireless - Automatic through Step 5.
2.
The player searches for a network, and then displays the connection failed
message.
3.
On the bottom of the screen, select IP Settings, and then press the
E
button.
The IP Settings screen appears.
4.
Select the IP Setting field, and then press the
E
button.
5.
Select Enter manually in the IP Setting field, and then press the
E
button.
6.
Select a value to enter (IP Address, for example), and then press
E
button.
Use the number keypad on your remote control to enter the numbers for the
value. You can also enter numbers using the ▲▼ buttons. Use the ◀▶ buttons
on the remote control to move from entry field to entry field within a value.
When done with one value, press the
E
button.
7.
Press the ▲ or ▼ button to move to another value, and then enter the numbers
for that value following the instructions in Step 6.
8.
Repeat Steps 6 and 7 until you have filled in all values.
"
You can get the Network values from your Internet provider.
9.
When finished, select OK, and then press the
E
button. The Security Screen
appears.
10.
On the Security screen, enter your network's Security Code or Pass Phrase.
Enter numbers directly using the number buttons on your remote control. Enter
letters by selecting a letter with the ▲▼◀▶ buttons, and then pressing the
E
button.
11.
When finished, select Done at the right of the screen, and then press the
E
button. The player verifies the network connection and then connects to the
network.
12.
After the player verifies the network, select OK, and then press the
E
button.