Filter
Top Products
- English
▶ If you want to install the speakers on the wall, fasten screws or nails (not provided) firmly to the wall
wherever you want to hang a speaker, and then, using the hole in the rear of each speaker, carefully
hang each speaker on a screw or nail.
▶ Do not let children play with or near the speakers. They could get hurt if a speaker falls.
▶ When connecting the speaker wires to the speakers, make sure that the polarity (+/ –) is correct.
▶ Keep the subwoofer speaker out of reach of children to prevent children from inserting their hands
or alien substances into the duct (hole) of the subwoofer speaker.
▶ Do not hang the subwoofer on the wall using the duct (hole).
▶ The wireless receiving antenna is built into the wireless receiver module. Keep it away from water
and moisture.
▶ For optimal listening performance, make sure that the area around the wireless receiver module
location is clear of any obstructions.
▶ In 2-CH mode, you will hear no sound from the wireless surround speakers.
Attaching the Toroidal Ferrite Core to the Power Cord of the Wireless
Receiver Module (SWA-6000)
If you attach a Toroidal ferrite core to the power cord of the
wireless receiver module, it will help prevent RF interference from
radio signals.
Pull the fixing tab of the Toroidal ferrite core to open it.
Make two loops in the wireless receiver module power cord.
Attach the Toroidal ferrite core to the wireless receiver
module's power cord as shown in the figure on the right, and
then close it by pressing it until it clicks.
~
Attach the ferrite core as close to the Wireless Receiver
Module as possible.