Filter
Top Products
SETTING THE EVENT
You can make the setup for record in case of sensor detection, camera event or video loss detection.
Sensor Detection
You can set the sensor's operating condition and connected camera, as well as alarm output and its duration.
[MENU] Ö [ENTER] Ö ▼ Ö <Menu> Ö [ENTER] Ö ▼ Ö <Event> Ö ► Ö <Sensor Detection> Ö
[ENTER] Ö ▼ Ö <NVR> Ö ▲▼◄► Ö [ENTER]
•
Apply to other sensors : If you select <Apply to other sensors>, the "Apply to other sensors" confirmation
window will appear.
After selecting channels that the settings will be applied to, click on <OK> to apply them to the selected
channels.
•
Sensor Operation : Sets the operation mode of sensors.
` In the <Camera> tab, you can set whether or not to use a sensor.
-
<N.O (Normal Open)> : Sensor is opened. If the sensor is closed, it generates alarm.
-
<N.C (Normal Close)> : Sensor is closed. If the sensor is open, it generates alarm.
•
Cam : Select a channel to be connected to the sensor.
If selected camera, "Cam Preset setup" window appears.
Select a channel and setup the preset.
` Preset setup can be done in PTZ mode.
•
Alarm out : Sets the alarm output method.
` For further information on alarm output, refer to "HDD Alarm > Alarm". (Page 66)
•
Duration : Sets the duration of alarm signal and alarm sound.
M
`
If you select <Camera> tab, you can configure the sensor operation settings of the network camera connected to each channel.
`
If the connected network camera that has configured the alarm in/out settings triggers an alarm, NVR will perform the alarm out.
English _73
● MENU SETUP