Filter
Top Products
CONNECTING WEB VIEWER
1. Open your web browser and type the IP address or URL of
NVR into the URL address box.
M
` You need to connect network 2 before you can access the web
viewer.
` "192.168.2.200" is set to IP by default.
` You must have specified the IP address in "Network > Interface".
` The URL connection will be enabled only when the DDNS connection settings have been completed.
For more information, refer to "Network Configuration > DDNS". (Page 80)
2. A user with the admin permissions should provide the admin
ID and password. A registered user should provide the user
ID and password.
J
` The initial admin ID/password for your web viewer are "admin" and
"4321" and you need to reset them in the easy setup phase.
Easy setup can be used only in the initial setup of the product.
` Set password for your wireless network if you use the product with
a wireless router. Being not protected with password or using the default wireless router password may expose your video
data to potential threat.
` Please change your password every three months to safely protect personal information and to prevent the damage of the
information theft.
Please, take note that it's a user's responsibility for the security and any other problems caused by mismanaging a
password.
M
` It allow s up to 10 simultaneous access including the Admin and general users.
` Password of the Admin and general users can be changed in <Permission Setup> menu of the NVR.
` Normal users should have set <Webviewer> under <Restriction on Network Access> to Use before connecting to the
Web Viewer. (Page 45)
` All settings are applied by the NVR's settings.
3. The plugin installation confirmation pop-up window will
appear.
94_ starting web viewer
starting web viewer