Filter
Top Products
English 23
3 RECORDING
Use the following procedure to record the monitored video
in the normal recording area.
Recording will not be possible until a time has been set for
the digital video recorder. Make sure to set the time.
(JP.17)
1 Press the [REC/STOP] button.
The REC/STOP indicator lights up, “REC” appears on-
screen (i.e., the recording symbol), and recording starts.
z When recording for the first time, the default settings
are used. For details regarding modification of the
picture quality or recording rate, see P.71.
z When the space remaining in the normal recording area
drops below a preset value, the FULL indicator on the
digital video recorder’s front panel starts to flash. If
recording is continued beyond this point, the normal
recording area will become full, recording will stop, and
the FULL indicator will stop flashing and remain lit. In
such a case, use the <RECORDING AREA SET>
screen to perform “AREA FULL RESET” for the normal
recording area, thus allowing recording to start again
from the beginning. (JP.67)
z Playback is possible even while recording. See P.26 for
more details.
2 Press and hold the [REC/STOP] button
for approximately 3 seconds.
“REC” disappears from the operation display and
recording ends.
Use the following procedure to record the monitored video
for a preset length of time in the normal recording area.
Recording will not be possible until a time has been set for
the digital video recorder. Make sure to set the time. (
J
P.17)
1 Press the [TIMER] button.
The TIMER indicator lights up and the digital video
recorder enters timer recording standby mode.
(1) See P.74 for more details on timer recording settings.
(2) At the time specified for the start of timer recording, the
REC/STOP indicator lights up, “REC” appears on-
screen (i.e., the recording symbol), and recording starts.
(3) At the time specified for the end of timer recording, the
REC/STOP indicator turns off, and recording ends.
The [TIMER] button remains lit up.
z When the space remaining in the normal recording area
drops below a preset value, the FULL indicator on the
digital video recorder’s front panel starts to flash. If
recording is continued beyond this point, the normal
recording area will become full, recording will stop, and
the FULL indicator will stop flashing and remain lit. In
such a case, use the <RECORDING AREA SET> menu
to perform “AREA FULL RESET” for the normal
recording area, thus allowing recording to start again
from the beginning. (JP.67)
z Playback is possible even while recording. See P.26 for
more details.
2 Press the [TIMER] button.
The TIMER indicator turns off and recording ends.
CARDCARD
MENU
RESET
EJECT
[REC/STOP] button [TIMER] button
FULL indicator
POWER indicator
Normal recording
Ending normal recording
02
0
01-01-04 00:00:00 REC REPEAT EN A ALARM 0000
Recording symbol
REC/STOP
REC/STOP
Timer recording
Stopping timer recording before completion
02
0
01-01-04 00:00:00 REC REPEAT EN A ALARM 0000
TIMER
TIMER
e00_l8hbg_us_7.book Page 23 Thursday, November 25, 2004 1:44 PM