Filter
Top Products
RECORD SET3
82 English
SETTINGS
1 Make timer settings for “TIME PERIOD
A” and “TIME PERIOD B” from <TIME
PERIOD SET>. (JP.57)
2 Turn the jog dial select “MOTION
SENSOR”, and then turn the shuttle dial
clockwise.
The motion sensor screen is displayed.
3 Press the [CAMERA SELECT] button.
Select the camera for which motion sensors are to be
setup.
4 Turn the jog dial clockwise or counter-
clockwise to move the cursor (blue) to
the position where a sensor is to be set.
5 Turn the shuttle dial clockwise, and
then turn the jog dial to select “A” or
“B”.
“A” or “B” : Sensor set
“-” : No sensor
6 Turn the shuttle dial clockwise.
After confirming this setting, the cursor (blue) moves one
position to the right.
7 Use this procedure to set other sensor
positions.
z All sensors on the same line as the cursor can be
modified simultaneously by pressing the [MENU
RESET] button. (A → B → -)
8 Turn the jog dial to move the cursor to
“T-1”, and then turn the shuttle dial
clockwise.
“T-1” flashes.
9 Turn the jog dial to select T-1, T-2, T-3,
or T-4, and then turn the shuttle dial
clockwise.
The cursor moves to “LEVEL”.
10 Turn the shuttle dial clockwise.
“OFF” flashes for “LEVEL”.
<ALARM REC MODE SET>
ALARM RECORDING : ENABLED
PICTURE QUALITY : ENHANCED
AUDIO RECORDING : ON
ALARM INTERLEAVE : ONLY
REC RATE: A 15FPS, DURATION: 20SEC
PRE-ALARM RECORDING : ON
REC RATE: A 15FPS, DURATION: 1MIN
=> (00371 ALARMS CAN BE RECORDED)
ALARM TRIGGER : SENSOR
MOTION SENSOR ->
CH01 T-1 LEVEL : OFF MODE : A
The cursor (blue) is
displayed at the top left
position.
A
CH01 T-1 LEVEL : OFF MODE : A
A
CH01 T-1 LEVEL : OFF MODE : A
A
CH01 T-2 LEVEL : OFF MODE : A
e00_l8hbg_us_7.book Page 82 Thursday, November 25, 2004 1:44 PM