Filter
Top Products
12
TV CHANNEL SETUP
9. The channel scanning starts. This process may
take a few minutes.
10.When all the TV channels have been searched
and stored, press [SETUP] to exit.
Notes:
1. If the available channel number in your residence area
exceeds the maximum receivable channel numbers of this
DVD Recorder, the scan will be discontinued. The maxi
mum receivable channel numbers are:
Antenna: 168 (chs)
Cable: 104 (chs)
Auto: 176 (chs)
2. It would take more time for auto channel scanning
depending on the receiving condition of your antenna.
Fine-tuning TV channels manually
After you have performed the channel scanning, you may like
to fine-tune the TV channel signal manually. Follow the steps
below to complete fine tune.
1. Press [SETUP] to display the “Setup”, press
[] or [] to select the “TV Tuner” icon and
press [].
2. Press [] or [ ] to select “Fine Tune” and
press [].
3. Press [] or [] to fine-tune the channel signal.
4. When complete, press [SETUP] to exit the
setup menu.
Editing TV channels manually
After you have performed channel scanning, you may like to
further edit the TV channels. This function allows manually
adding/deleting channels, swapping channel order, inserting
a channel to a specific order, renaming the channels and so
on.
1. Press [SETUP] to display the “Setup”, press
[] or [] to select the “TV Tuner” icon and
press [].
2. Press [] or [] to select “Utilities” and press
[].
3. Press [] or [] to select “Edit Channel” and
press [ENTER]. The CHANNEL EDITOR menu will be
displayed.
For detailed operation instructions on the “Channel Editor”
menu, refer to the “CHANNEL EDITOR” section.
TV channel scanning
When the “Scan Channel” function is activated, the TV
channels are searched and stored in a specific order. If the
channel assignment of your TV content provider is changed
or if you are reinstalling this DVD recorder, you may need to
start this procedure again.This will replace the TV channel
stored with the new ones.
Before scanning channel, set the “TV Signal” and “Country”
for initiation.
1. Ensure the antennas are securely connected to
the DVD recorder.
2. Switch on the TV set and the DVD recorder.
3. Press [SETUP] to display the setup menu, press
[] or [] to select the “TV Tuner” icon and
press [].
4. Press [] / [] to select “TV Signal” and press
[ ].
5. Press [] / [] to select “Cable,” “Antenna” or
“Auto” depending on how you receive your
terrestrial TV channels and press [ENTER]. Press
[ ] to return to the previous menu and save the
setting.
If you select “Auto,” the unit will automatically scan both
channels available at cable and antenna connections, which
might take longer than needed.
6. Press [] / [] to select “Country” and press
[]. Press [] / [] and [ENTER] to select the
country of your residence from the list . Press []
to return to the previous menu and save the
setting.
7. Press [] / [] to select “Utilities” and press [].
8. Press [] / [] to select “Scan Channel” and
press [ENTER] to start channel scanning.
If you wish to stop scanning, move to “Stop Scan” and press
[ENTER]. The scanning process will be discontinued.