Filter
Top Products
14
Thanks to this programming system, you no longer need to
tediously enter the date, programme number, start and end
times. All the information needed by the DVD recorder for
programming is contained in the VIDEO Plus+
®
programming
number. This 9-digit PlusCode number is found in most TV
listings magazines.
Before setting up, confirm that the all cables are securely
connected.
Setting up VIDEO Plus+
®
systemCHANN EL EDITOR
Turning on or turning off TV channels manually
After you have performed the channel scanning process, you
may like to add or delete some of the TV channels. This function
allows turning on the channel not found at channel scanning or
turning off the channel found manually.
1. Press [] [] to select a TV Channel not found at
channel scanning and press [].
2. Press [] [] to select “Turn On” and press
[ENTER]. The TV channel selected will be turned
on.
To turn off the TV channel, move to “Turn Off” and press
[ENTER]. The TV channel selected will be turned off.
3. To turn on other TV channels, repeat step 1~2 to
complete the settings.
4. Press [] [][] [] to select “Exit,” press
[ENTER] to save the setting and exit the
“CHANNEL EDITOR” menu.
SettinguptheVIDEOPlus+
®
system
1. Press [SOURCE] to set TV as the input signal
source.
2. Press [EDIT] to display the “CHANNEL EDITOR”
menu.
3. Press [] [] to go to a channel and press
[ENTER].
4. Press [] [ ] [] [] to go to “GCN” and press
[ENTER].
The menu to enter GCN is displayed.
5. Use the numbered buttons (1~9) to enter the
GCN and press [ENTER] when done.
Press [] [] to go back to advance/return to the previous/
next digit.
6. To set GCN for other channels, repeat step 3~5.
7. When complete, press [] / [] to go to “Exit”
and press [ENTER] to exit the channel editor
menu.
PDC
“PDC” (program delivery control) are used to control
the start and duration of TV channel recordings. If a TV
program starts earlier or ends later than was
scheduled, the DVD recorder will then turn on and off
at the correct time. Refer to “Timer Record using the
VIDEO Plus+ system” section for details about setting.
Notes:
1. You must enter the start time exactly to the minute. If you
want to program a time that is different from the PDC time,
you must switch off PDC.
2. Only on TV program of a TV channel can be controlled
using “PDC” at a time. If you want to record two or more
TV programs on a TV channel using “PDC,” you need to
program these as two separate recordings.
3. Since the DVD recorder requires a certain lead time for
getting the disc up to speed and positioning the laser before
recording can start, it is possible that the recorder will miss
the first few seconds of a TV show recorded with PDC. In
this case, disable PDC and enter a start time one minute
earlier.