Filter
Top Products
Chapter 6 Setup Menu
122 Chapter 6 Setup Menu
Extended Menu
Monitor screen
3 Holding down the STOP button, turn the search
dial to move the cursor to select a combination of
input and recording channels.
4 Holding down the SEARCH button, turn the
search dial to set the channel selection made in
step 3 to on or off.
To select an input channel for recording
For the selected recording channel, set the desired
input channel to on.
To record, mixing more than one input signal
For the selected recording channel, set two or more
of the input channels to on. All of the input
channels set to on for each recording channel will
be mixed for that channel.
To switch on the sound-on-sound setting
In addition to the selected input channel(s), set
“tape” to “on.”
5 Repeat steps 3 and 4 for each of the recording
channels.
6 Press the SET button.
This saves the settings.
Cursor (shows the item selected for menu operations)
ITEM-819
AUDIO INPUT SOURCE
ARRANGE
ch1:
ch2:
ch3:
ch4:
in1 in2 in3 in4 tape
--------------------
on
on
on
on
*on
Recording channel numbers
Input channel numbers
To enable the setting of extension menu item
819
Press the MIXING button in the upper control panel,
turning it on.
When the MIXING button is off, the settings of
extension menu item 819 are ignored, and the input
channels and recording channels are recorded one-to-
one. It is not possible to carry out mixing or channel
switching.
Note
When 2-channel mode (2CH) is selected for audio
recording (see extended menu item 818), the settings
made with this item for input channels 3 and 4 (in3 and
in4) as well as recording channels 3 and 4 (ch3 and
ch4) are invalid.
For example, when input channels 1 and 3 (in1 and
in3) are set to on for recording channel 1 (ch1), in 2CH
mode, only the signal from input channel 1 is recorded
on recording channel 1.