Filter
Top Products
Chapter 4 Editing
Chapter 4 Editing 81
Monitor output during an edit
During execution of an automatic edit, on a monitor connected to the
recorder, you can monitor the same video and audio as during a preview
(see page 80).
However, during preread editing (see page 86), only the playback from the
recorder can be monitored.
Using a single monitor for video and audio on both player and recorder
For efficient editing if only one monitor is available, use the following
method.
1 Connect the monitor to the recorder.
2 In the setup menus, set item 008 to “AUTO”.
3 Press the PLAYER button on the recorder.
This forces the recorder to E-E mode, in which the player video and
audio signals are output to the monitor.
Note
Continuous recording must exist on the recorder tape to be used in issert
editing. It is not possible to carry out editing on a section of the tape with
no signal recorded.
Starting automatic editing
When you have set the edit points, press the flashing AUTO EDIT button.
The AUTO EDIT button changes from flashing to continuously lit, and the
automatic editing operation begins.
At the end of the editing operation, the AUTO EDIT button goes off.
ENTRY/SHIFT button
DELETE button
AUTO EDIT button
PREVIEW button
REVIEW button
OUT button STOP button