Filter
Top Products
Chapter 3 Recording and Playback
Chapter 3 Recording and Playback 57
7 Turn the search dial to vary the playback speed.
While the MEMORY indicator is flashing, the speed variations are
stored in memory. On passing the speed variation end point, the
MEMORY indicator changes from flashing to continuously lit, and the
variable speed storing ends.
8 Press the STOP button to stop the tape.
If the MEMORY indicator lights continuously before the speed
variation end point
This indicates that the memory became full at that point. It is therefore not
possible to record more speed variation. The maximum capacity is a
duration of 120 seconds.
To amend the stored speed variation
Press the PREVIEW button.
The interval between the speed variation start and end points is
automatically played back at the stored speed. Operate the search dial as
required, to adjust the playback speed.
Setting the initial speed to normal speed
In step 5, press the PLAY button.
Executing DMC Playback
There are two methods of starting DMC playback.
• Starting playback at the on-air cue from the on-air start point
• Starting playback immediately after preroll
Notes
• To avoid operating mistakes we recommend that you use the VCR in
standalone mode when carrying out DMC playback.
• When using two VCRs connected for editing, you can only use the
recorder VCR for DMC playback, and only when both the RECORDER
and PLAYER buttons are off.