Filter
Top Products
Chapter 1 Overview
Chapter 1 Overview 13
Location and Function of Parts
There are four control panels as shown in the figure
below.
To adjust the position of the lower control
panel
You can fix the lower control panel in any position
between vertical and horizontal for ease of operation.
Connector panel
(See page 29.)
Upper control panel
(See page 14.)
Lower control panel
(See page 17.)
Subsidiary control panel
(See page 26.)
Handle
Lock knob
Release lever
Raise the panel by holding both ends or
both handles.
When the panel is at the desired angle,
turn both lock knobs to fix in position.
If you raise the panel to the horizontal, it
automatically locks in position.
To lower the panel, press both
release levers.
To fix the panel at an angle where the lock knobs are inaccessible
1 First position the panel at the desired angle, then without tightening the lock knobs, press the release levers
and raise the panel to the horizontal.
2 With the panel horizontal, tighten the lock knobs, then press the release levers and return the panel to the
desired position, where it will lock into place.