Sony KLV-V32A10 Flat Panel Television User Manual


 
KLV-V40A10
2-682-277-11(1)
Getting Started
17
GB
6: Auto-programming
the TV
After selecting the language, a message confirming
that the TV starts auto program appears on the screen.
You must tune the TV to receive channels (TV
broadcasts). Do the following to search and store all
available channels.
Press to select “Yes”.
The TV starts searching for all available channels.
This may take some time. Do not press any buttons on
the TV or remote until it is completed.
Once all available channels have been stored, the TV
returns to normal operation, displaying the channel
stored on channel number 1.
Tip
If you press any of the buttons during auto-programming,
auto-programming operation is canceled. To perform auto-
programming again, activate “Initial Reset” in the “Setup”
menu (page 45).
When a message appears for you to confirm the
antenna connections
No channels are found. Check all the antenna
connections and press to start auto-program again.
To change the order in which the channels
are stored on the TV
See page 42.
01
Program TV System
VHF Low
Press any key to cancel
Auto
Initial Setup
End:
WEGA GATE
m
010COV.book Page 17 Tuesday, May 23, 2006 9:06 AM