Sony KLV-V32A10 Flat Panel Television User Manual


 
KLV-V40A10
2-682-277-11(1)
Additional Information
57
GB
“Cannot cancel the protection”
is displayed
The picture is protected and also the Memory Stick is locked.
“File access...Please wait!” is
displayed
The TV is loading data from the camera. Wait until the message disappears.
“File error” is displayed
The file name has a total of more than 68 characters in it.
“Too many files” is displayed
The maximum number of files the Photo Viewer can display is 2,000 files in
the Digi. Cam. Mode. You can view the files after selecting folders
(page 27).
The file name is not displayed
correctly
The file name has been processed by a computer.
The USB device does not work
Only Sony cameras and camcorders are supported. Most current Sony
digital still cameras and camcorders are supported but some may not work
correctly.
The connected USB device is unsupported. Cameras from other
manufacturers, and non-camera USB devices (printers, USB readers, etc.)
may not work correctly.
The Photo Viewer does not
start
Turn off the TV and then turn it on again.
Cannot edit the files
If your digital still camera has an internal memory, you can view the files in
the internal memory but cannot edit them. To edit the files, make a copy to a
media such as a Memory Stick.
Cannot show (or hide) file
information in full screen or
during Slide Show
Set the Information option to On (or Off) (page 29).
Others
Problem Cause/Remedy
The TV turns off automatically
(the TV enters standby mode)
Check to see if the Sleep Timer function is activated (page 46).
Some input sources cannot be
selected
Select “Video Label” in the “Setup” menu and cancel “Skip” of the input
source (page 44).
No picture but “PC” indication
appears when the TV is turned
on
The TV was set to the standby mode by the Power Management function
(page 44). Select a channel.
The remote does not function
Check that the remote is set correctly for the equipment you are using
(VCR, TV, or DVD).
If the remote does not operate the VCR or DVD even if the remote has been
programmed, try another code (page 49).
Replace the batteries.
Tape/disc operation buttons do
not work
The equipment is not selected. Press the function button of the equipment
you want to operate.
The tape/disc operation buttons light up when pressed even if the remote is
in the TV operation mode. In this case, they do not work.
Problem Cause/Remedy
010COV.book Page 57 Tuesday, May 23, 2006 9:06 AM