Sony KLV-V32A10 Flat Panel Television User Manual


 
KLV-V40A10
2-682-277-11(1)
Using Optional Equipment
49
GB
Programming the
remote
If you have Sony VCRs/DVDs and Sony DVD Home
Theater Systems/Amplifiers, do the following
procedure to program the remote so that you can
operate them using this remote.
Note
Before you start, look up the three-digit code for your
equipment on the right. For equipment that has more than
one code, try with the first code number.
1 Press and hold the DVD, VCR, or AMP
function button you want to program on the
remote and press the
/ button
simultaneously.
The selected function button (DVD, VCR, or
AMP) will flash.
2 Enter the three-digit code using the number
buttons while the function button is lit (for
approximately 10 seconds).
3 Press /-/-- or to complete the
programming.
When the programming is done successfully, the
selected function button will flash twice slowly, and
if not, will flash five times quickly.
To connect Do this
Digital satellite
receiver or digital
terrestrial receiver
E
Connect only to the HDMI IN
jack. The digital video and audio
signals are input from the digital
satellite receiver.
Tip
If the digital satellite receiver has an
HDMI jack, connecting via an HDMI
cable will provide the best results.
Note
When using an HDMI-to-DVI cable
or an adapter, be sure to connect the
DVI output connector first; then
connect to the HDMI jack on the TV.
DVD recorder or
VCR F
Connect to the video output jacks
to record the image from the
TV. Connect to the audio output
jacks to record the sound from
the TV on the DVD recorder or
VCR. To turn off the sound of the
TV speakers, set “Speaker” to
“Off” (page 37).
DVD player with
component output
G
Connect to the component jack
1, 2 and the audio jacks
1, 2. For better picture quality,
component connection is
recommended if your DVD player
has a component output.
Video game
equipment, DVD
player without
component video
output, or VCR
HI
Connect to the S video jack 1
or the video jack 1, 2 or 3, and
the audio jacks 1, 2 or 3. To
avoid picture noise, do not connect
the camcorder to the video jack
1 and the S video jack 1
at the same time. If you connect
mono equipment, connect to the L
(MONO) jack 1, 2 or 3.
Hi-Fi audio
equipment J
Connect to the audio output jacks
to listen to the sound from the
TV on the Hi-Fi audio equipment.
To turn off the sound of the TV
speakers, set “Speaker” to “Off”
(page 37).
1
2
1
3
010COV.book Page 49 Tuesday, May 23, 2006 9:06 AM