Filter
Top Products
25
Connections and Settings
Chapter 2 Preparations
See “Using PDZ-1 Proxy Browsing Software” in Chapter
4 (page 68) for more information about installing the
PDZ-1 software. See the online help of PDZ-1 for more
information about using PDZ-1.
Some limitations apply to FAM connections. For details,
see “File Operations in File Access Mode” in Chapter 5
(page 72).
Connecting to a Nonlinear Editing
System (AV/C Connection)
You can send video/audio signals (AV/C data) from this
unit to a nonlinear editing system connected to the S400
connector.
The following figure shows an example connection.
See “Using PDZ-1 Over an i.LINK Connection (FAM
Connection)” (page 24) for the connections and settings to
make a FAM connection between this unit and a nonlinear
editing system.
• The S400 connector of this unit outputs video/audio
signals in DVCAM format. Data recorded in MPEG HD
format is output after being converted into DVCAM
format.
• The nonlinear editing system to be connected to this unit
requires editing software (not supplied) supporting the
DVCAM format.
• To transfer video and audio signals (AV/C data), use
AUDIO CONTROL >DV OUT MODE (see page 85) in
the setup menu to select the audio mode (the factory
default is “2ch”).
• This unit’s S400 connector has 6 pins. Check the
number of pins on the i.LINK connector of your laptop
computer, and use an appropriate i.LINK cable.
Connections for Cut Editing
By connecting this unit to a VTR, you can configure a cut
editing system. Some example connections are shown in
the following.
When making the connections, also refer to the manuals
provided with the equipment to be connected.
When using the editing functions of the
recorder (connections using the S400
connector)
The following figure shows a cut editing system
comprising this unit as a player and a DSR-2000A/2000AP
unit as a recorder. In this system, video/audio signals and
control signals are all transferred through the S400
connector.
On the computer On this unit
Install PDZ-1. Set the setup menu item
INTERFACE SELECT >i.LINK
MODE to “FAM(PC REMOTE)”
(see page 85).
Notes
POWER
COMPOSITE OUT AUDIO MONITOR
AUDIO OUTPUT
1/3 2/4
RL
RS232C REMOTE(9P)
S400
-AC IN
MONITOR
S400
PDW-F30 (this unit)
i.LINK cable
(not supplied)
i.LINK (IEEE1394) connector
Laptop computer
On the computer On this unit
Install editing software
supporting the DVCAM
format.
Set the setup menu item
INTERFACE SELECT
>REMOTE I/F to “i.LINK” (see
page 85).
Set the setup menu item
INTERFACE SELECT >i.LINK
MODE to “AV/C” (see page
85).
POWER
COMPOSITE OUT AUDIO MONITOR
AUDIO OUTPUT
1/3 2/4
RL
RS232C REMOTE(9P)
S400
-AC IN
MONITOR
S400
Laptop computer
i.LINK (IEEE1394) connector
i.LINK cable
(not supplied)
PDW-F30 (this unit)