Filter
Top Products
76
Function Menu
Chapter 6 Menus
Page P1
F3: MONI SEL (monitor
selection)
Selects the audio monitor
signal output from the AUDIO
MONITOR connector and the
PHONES jack.
STEREO: Assign the channels
selected with MONI CH to
left and right.
MONO L (monaural L
channel): Output one of
the channels selected with
MONI CH.
MONO R (monaural R
channel): Output one of
the channels selected with
MONI CH.
MIX: Output monaural audio
mixed from the channels
selected with MONI CH.
F4: REC INH (recording
inhibit)
Turns recording inhibit mode
on and off.
ON: Recording inhibit mode on
OFF: Recording inhibit mode
off
F5: CHAR SEL (Character
information display)
Turns the display of character
information in the monitor video
section of the LCD panel and
on an external monitor on and
off.
ON: Character information on
OFF: Character information off
LCD: Character information on
for the LCD panel only
Even when ON is selected, you
can forcibly turn off the
superimposition of character
information in HD output by
setting the SETUP MENU
>DISPLAY CONTROL >HD
CHARA item.
Setting item Description
F2: TC MODE (timecode
mode)
Selects whether the count
value advances from a preset
initial value, or advances
consecutively from the
timecode of the last frame
recorded on the disc.
PRESET: Advance from a
preset initial value.
REGEN (regenerate):
Advance consecutively
from the timecode of the
last frame recorded on the
disc.
Setting item Description
F3: RUN MODE When TCG is set to “INT”, and
TC MODE is set to “PRESET”,
selects the run mode of the
internal timecode generator.
REC RUN: The timecode
generator runs only during
recording.
FREE RUN: The timecode
generator runs as long as
the unit is powered on.
F4: TC/VITC Selects the type of timecode
display in the time data display
section (TC or VITC).
F5: DF/NDF
(only when the system
frequency is 60I/30P/24P
pulldown)
Use this item to select drop-
frame mode (DF) or non-drop-
frame mode (NDF).
Setting item Description