Filter
Top Products
32
Superimposed Text Information
Chapter 2 Preparations
8
Press the M/MARK1 or m/MARK2 button to select
“TIME DATA ONLY”.
9
Press the SET button.
The setting is confirmed.
10
Turn the display of character information on.
For details, see “To turn superimposed text on and
off” (page 32).
As shown below, you can display 24-frame timecode
at the same time as 30-frame pulldown timecode.
Superimposed Text
Information
The composite signals output from the COMPOSITE OUT
connector can contain superimposed text information,
including timecode, menu settings, and alarm messages.
To turn superimposed text on and off
Set the CHAR SEL item on page P1 of the function menu.
ON: Display superimposed text.
OFF: Do not display superimposed text.
LCD: Display superimposed text on the LCD panel of this
unit, but do not display it on an external video monitor
connected to this unit.
Even when ON is selected, you can forcibly turn off the
superimposition of character information in HD output by
setting the SETUP MENU >DISPLAY CONTROL >HD
CHARA item.
Adjusting the text display
You can use the items in the DISPLAY CONTROL setup
menu to specify the position, size, and type of
superimposed characters.
See page 81 for more information about the items in the
DISPLAY CONTROL menu.
Information displayed
a) Only when the system frequency is 60I/30P.
SETUP MENU
:T&STA
DISPLAY CONTROL
DISPLAY INFO
* TIME DATA & STATUS
TIME DATA & UB
TIME DATA & CNT
TIME DATA & TIME
TIME DATA & CLIP
TIME DATA ONLY
LTC 00:59:59:23
PDT 00:59.59:28
Note
TCR 00:04.47.07*
PLAY LOCK
1 Type of time data
2 Timecode reader drop
frame mark
a)
3 Timecode generator drop
frame mark
a)
4 VITC field mark
5 Menu setting states
6 Operation mode
Time data