Filter
Top Products
16
Getting ready
he steps to be taken when preparing the unit for use will differ, depending on whether a wireless
LAN or network cable is used for connection to the computer.
1. Prepare remote control for use c Page 00
The remote control is necessary for operation of the unit.
2. Connect Network Media Receiver to TV c Page 00
Select a suitable connector and cable according to the requirements of the TV monitor. It is also
possible to make the connection to the TV via a VCR.
3. Connect Network Media Receiver to computer via network cable c Page 00
Connect the Network Media Receiver to the computer using network cable. When using a
wireless connection, this step is not required.
4. Connect power c Page 00
Connect the supplied AC adapter to the Network Media Receiver to supply power.
5. Make wireless LAN settings c Page 00
When the Network Media Receiver is to be connected to the computer via a wireless link,
without using network cable, a number of wireless LAN settings must be made. When using a
network cable connection, this step is not required.
6. Change settings of Network Media Receiver to match c Page 00
network connection
Depending on the network environment, some settings of the Network Media Receiver may
have to be changed, deciding whether to obtain an IP address automatically or use a fixed
address. In the default condition, the Network Media Receiver is set to ??? “Obtain an IP
address automatically” ???.
7. Make required settings at computer c Page 00
Prepare the computer for sending and receiving data.
When using a VAIO computer, VAIO Media settings must be made.
When using a different kind of computer, corresponding settings must be made.