Filter
Top Products
Setup
27
To connect the Network Media Receiver to a network
Connect the Network Media Receiver and the computer using the supplied network cable, as shown
below.
Case 1: Connecting via a router with built-in hub (system environment C, D, G)
*1
The connection may be different, depending on the respective system connection environment. For
details, contact the technical support department of your Internet provider.
*2
Use a router with built-in hub that supports 100BASE-TX.
Notes
• When a router with built-in hub is used in environment
G
, set the IP address of the computer to a fixed
value, as described in “Assigning a fixed IP address to the computer” (page 00).
• The factory default setting of the Network Media Receiver is ??? “Obtain an IP address automatically
(router present)” ???. Depending on your system environment, this setting may have to be changed. For
information on how to do this, see page 00.
When a router with built-in hub is used in environment
G
,
nothing is connected to the WAN port.
ADSL modem, cable modem or
similar without router capability *
1
(third-party)
Network cable
(not supplied)
Router with built-in
hub *
2
(third-party)
Network cable
(supplied)
To NETWORK
connector
Computer 1
To NETWORK
connector
Network Media Receiver
To NETWORK
connector
Network cable
(not supplied)
Computer 2