Operating the Equipment Locally
Instruction Manual: evolution 5000 E57xx DSNG and DENG Voyager Encoder Page 4-85
ST.TM.E10076.3
Preset Pwr Norm Option
Refer to Preset Pwr Norm Option on page 4-81 for details.
Upconverter Power
To access the Upconverter Power option, press the Upconverter Power
softkey in the Satellite Modulator Menu. This option allows the +24 Vdc
power on the L-Band Modulator Main output to be either Enabled or
Disabled.
NOTE…
The modulator provides dc power to drive an upconverter. Do not connect equipment to the main
output which might be damaged by dc power without protecting with a suitable dc block.
Sat Deliv Freq Option
Refer to Sat Deliv Freq Option on page 4-82 for details.
Sat Orb Pos Option
Refer to Sat Orb Pos Option on page 4-82 for details.
Sat West/East Option
Refer to Sat West/East Option on page 4-82 for details.
Polarisation Option
Refer to Polarisation Option on page 4-83 for details.
Status Only Options for the Satellite Modulator Menu
The following options are for status only and cannot be changed.
· Baseband (BB) Card Option
· BB PCB Revision Option
· BB Mod Status Option
· BB Serial No. Option
· BB S/W Release Option
· BB CPLD F/W Release Option
· BB DSP F/W Release Option
· BB RNF F/W Release Option
· L-Band Output Card Type Option
· DPC Card Type Option
4.11.10 Output Format = OFDM Modulator (3.1 and later)
Output Option
To access the Output option, press the Output softkey in the OFDM
Modulator Menu. This enables the modulator outputs to be switched On or
Off.