Filter
Top Products
Technical Specification
Page B-18 Instruction Manual: evolution 5000 E57xx DSNG and DENG Voyager Encoder
ST.TM.E10076.3
B.8.2 EMC
2
The equipment has been designed and tested to meet the following:
EN 55022
and
AS/NZS 3548
European
Australia and
New Zealand
Emission Standard
Limits and methods of measurement of
radio frequency interference
characteristics of information
technology equipment - Class A.
EN 61000-3-2
3
European Electromagnetic Compatibility (EMC),
Part 3 Limits; Section 2. Limits for
harmonic current emissions (equipment
input current £ 16 A per phase).
EN 61000-3-3
3
European Electromagnetic Compatibility (EMC),
Part 3. Limits; Section 3. Limitation of
voltage fluctuations and flicker in low
voltage supply systems for equipment
with rated current £ 16 A.
EN 55024:1998 European Information technology equipment -
Immunity characteristics - Limits and
methods of measurement.
FCC USA Conducted and radiated emission limits
for a Class A digital device, pursuant to
the Code of Federal Regulations (CFR)
Title 47-Telecommunications, Part 15:
Radio frequency devices, subpart B -
Unintentional Radiators.
B.8.3 Shock and Vibration
The Encoder and Receiver chassis complies with the requirements of
ETS 300-019-2-5 Table 2, for both non-operational and operational states,
without any special mounting or casing requirements over and above the
standard mounting requirements specified.
ETS 300-019-2-5 European Equipment Engineering (EE):
Environmental conditions and
environmental tests for
telecommunications equipment
Part 2-5: Specification of
environmental tests Ground Vehicle
Installations. Table 2.
2
The EMC tests were performed with the Technical Earth attached, and configured using recommended cables (see
Table B.29).
3
Applies only to models of the Encoder using mains (ac) power sources.