TANDBERG E5740 Flat Panel Television User Manual


 
Predefined User Configurations
Page C-4 Instruction Manual: evolution 5000 E57xx DSNG and DENG Voyager Encoder
ST.TM.E10076.3
Module Parameter Default Value
Output Mode Satellite
Setup Password Off
Display Errors Yes
LCD Brightness Medium
SNMP Control During Initialisation No Reply
System Type Local
Action on PID Error Auto Correct
MEM Error Handling Report Errors
IP Address 0.0.0.0
Network Mask 0.0.0.0
Gateway Address 0.0.0.0
Serial Number (if non-zero used for MAC
address)
0
SNMP Master 0.0.0.0
SNMP Trap Address 0.0.0.0
SABus Address 0x31
SABus Port RS-485
SABus Baud Rate 19200
SABus Data Bits 8, 1 stop bit
Mux: Active Clock Local Oscillator
On Air (ASI Output) On
Packet Length 188 bytes
PCR PID 0x1FFE
Bit-Rate (188) 40 Mbit/s
Bit-Rate (204) 43.404255 Mbit/s
Host Bit-Rate (Remux) 40 Mbit/s
Remux Mode Dumb
Scrambling (RAS/BISS) Off
SNG RAS1 Key 0000000
RAS1 Key 1 Not Set
RAS1 Key 2 (EBU) Not Set
RAS1 Key 3 (future extensions) Not Set
BISS-E Session Word Not Set
BISS Injected Id Not Set
BISS Code Not Set
Video Preprocessor: Frame Rate 25 Hz
Noise Reduction Off
Video Input Serial
Analogue Input Termination On
Output on Video Loss Freeze Frame
Audio 1-2 DID Auto (0x2FF)
Audio 3-4 DID Auto (0x1FD)
Analogue Calibration Calibrated
OSD from Flash Not Set