Filter
Top Products
5 − CD playback & recording
TASCAM DV-RA1000HD 39
To jump to a location mark, use the
JOG/DATA dial to highlight it in the list, and
press ENTER.
•
NOTE
This function is available for DVD±R discs.
Jumping to a mark
From the locate list, use F3 and F4 to start
editing the currently-highlighted mark.
Figure 5.9: Editing a mark
Use the cursor keys to highlight the time
fields and the JOG/DATA dial to edit these
fields, to slip the position of the mark.
•
•
Press ENTER when the editing is complete.
The mark is then highlighted, and you can
use it for location.
Use F1 (DEL) to delete the highlighted mark
from the list.
CAUTION
If you do not write the UDFMI information to disc,
the marks will not be saved. (See “Writing the
UDFMI” on page 40.
)
If you change the mark position, the locate list
will be automatically updated and sorted by time.
If you set a mark to a position beyond the end of
the track, the mark will automatically be placed
at the end of the track when you press the ENTER
key.
•
•
•
•
•
Editing marks
About marks
DVD±RW
HD
A maximum of 99 marks can be added to a disc (CD) or
to a project (DVD±RW/HD) to help with location, etc.
These marks can be edited.
NOTE
Although marks can be added to a CD recording
project (or to a pre-recorded CD), they are not
stored when the CD is ejected.
Marks can be stored on a DVD or in the HD as
information. Note, however, that the marks will
not be saved if you do not write the UDFMI to the
disc. (See “Writing the UDFMI” on page 40.)
You do not need to write the UDFMI manually in
an HDD project.
Press the MARK key to add a mark at the
point where the key was pressed. “Set
mark!” appears for a second to let you
know the mark has been set.
Marks can be added when stopped, paused,
playing back or recording.
•
•
•
•
•
Pressing and holding the DISPLAY key and
then pressing the MARK key brings up the
locate list screen.
Use the JOG/DATA dial to scroll through the
list. Marks are displayed in the order they
appear in the play list (DVD/HD). If the
play list order changes, so does the mark list
order.
Figure 5.8: The locate list
NOTE
The MARK key on the RC-RA1000 remote control
unit can be used to enter marks, and the LOCATE
key can be used to bring up the locate list.
•
•