Filter
Top Products
15
3.4 Video format (NTSC/PAL) selection
If the video format (NTSC/PAL) of the unit needs to be changed, pleases take the following steps.
If the unit is currently set to NTSC;
1, Push stop
button.
2, Hold down the
and pause
buttons simultaneously.
3, OSD massage "SET PAL, PLS RESTART" appears.
4, Restart the unit. The video format is now set to PAL.
To revert back to NTSC, repeat process.
Note: Video recorded in PAL format will not playback on NTSC setting. Likewise video
recorded in NTSC will not playback on PAL setting. It is recommended to reformat
HDD after changing video format.
16
4. BASIC OPERATIONS
This section shows you how to operate and manage the unit when it gets in the way.
4.1 Configuring Recording Settings
Recording Time settings (Recording Rate and Picture Quality Setting)
Recording time will vary depending on the image size, recording rate, and the capacity of hard-disk drive.
This unit ships with a 80GB hard disk for continuous recording from one to eight weeks under most
recording conditions. The table below shows recording times based on the 80GB hard-disk drive at certain
refresh rates and the corresponding image quality. With one or more hard-disk drives in operation, please
calculate the recording time using the table below in accordance with your requirements. For a NTSC unit,
for example, if the unit is set to record images with HIGH quality at a 60 fps record rate, normally a 80GB
hard-disk drive will be filled in 12 hours (See the gray area in the table). In a 2nd 80GB hard disk drive is
added, under the same refresh rate and picture quality, both drives will be filled in 24 hours.
Set up the REC Time Mode when a multiplexer is connected
For optimum image recording and playback when a Multiplexer is used, the record speed of the
multiplexer must be correctly adjusted to match the unit. Set the MULTIPLEXER option on the main menu
to ON. This can be done one of the two methods detailed below.
(1) If an Toshiba multiplexer is connected for use, you can program the REC time mode of the multiplexer
by referring to the table below (each refresh rate refers to one REC time mode).
(2) For a multiplexer other than Toshiba. Please, connect the SW. OUT terminal on the rear panel of the
DVR to the multiplexer’s trigger contact. The DVR will provide the timing signal (Negative/Falling) to the
multiplexer. Thus, if the DVR changes the recording speed, the multiplexer will automatically adjust the
record to match. The DVR doesn’t provide a 2-hour timing signal in NTSC or 3-hour timing signal in
PAL.
NTSC System
Possible Recording Time HDD=80 Gigabytes
Refresh Rate (Field/Sec)
60 20 10 5 2.5 1.25 0.625 0.25 0.16 0.125
HIGH
12 hr 36 hr 72 hr 144 hr 288 hr 576 hr 1008 hr 2880 hr 4320 hr 5760 hr
STANDARD
18 hr 54 hr 108 hr 216 hr 432 hr 864 hr 1512 hr 4320 hr 6480 hr 8640 hr
Image
Quality
BASIC
24 hr 72 hr 144 hr 288 hr 576 hr 1152 hr 2016 hr 5760 hr 8640 hr 11520 hr
REC Time Mode
2 hr 6 hr 12 hr 24 hr 48 hr 96 hr 168 hr 480 hr 720 hr 960 hr
REC interval (1/60 sec)
1 3 6 12 24 48 84 240 360 480
1-8