Filter
Top Products
37
5.7 SYSTEM
The SYSTEM PAGE is used for accessing the history of operation status, setting the password, resuming
factory default, and determining the menu display background.
LOG :
This log shows the history of the operation status in chronological order. The operation status is
described to the right of the time of each entry. There are seven possible entries as detailed
below.
ON : The device was powered up.
OFF : The device was powered off.
REC : Recording Started.
STOP : Recording stopped.
PLAY : Recorded Video was played back.
PAUSE : The display was paused.
V-IN : Video input was connected.
V-LOSS : Video loss occurred.
P-LOSS : Power interruption occurred.
Note: The log keeps an operation history on a revolving basis because of a limit in memory
space. When the log is full, the newly registered record of an operation will replace
the existing records from the oldest one.
MENU BACKGND :
The MENU BACKGND option is used for setting the background display of the menus.
ON : Background is blue.
OFF : Background is transparent.
FLICKER REDUCTION :
The FLICKER REDUCTION option is used to eliminate the flickering condition of an image as it
occurs during a playback picture by picture. Slight picture degradation may occur when using
this feature.
ON : FLICKER REDUCTION is enabled.
OFF : FLICKER REDUCTION is disabled.
05/15/01 18:19:32 ON
05/15/01 18:19:32 OFF
05/15/01 18:19:32 REC
05/15/01 18:19:32 STOP
05/15/01 18:19:32 PLAY
05/15/01 18:19:32 PAUSE
05/15/01 18:19:32 V-IN
05/15/01 18:19:32 V-LOSS
05/15/01 18:19:32 P-LOSS
MAIN MENU
TIME/ TITLE
RECORD TIMER
RECORD
ALARM
COMMUNICATION
DISK
SYSTEM
GO TO SYSTEM SETTING
SYSTEM PAGE
OPERATION LOG : ENTER
MENU BACKGND : OFF
FLICKER REDUCT : OFF
BUZZER : OFF
PASSWORD : SET
DEFAULT : LOAD
MAIN PAGE
V
IEW OPERATION LOG
38
BUZZER :
The BUZZER option is used to determine the embedded buzzer sounding a tone to signal the
following situations. A tone lasts about two seconds long.
Situation Status
Alarm Alarm takes place
Video Loss Video loss takes place
Disk Full Disk is full
Load Default Load factory default
Buzzer Buzzer set to ON
Key Lock Enable/disable key lock function
HD3 Power on /off mobile rack HDD
Backup Backup operation complete
Timer Timer activate/deactivate
HDD Recording switching between HDD
ON : BUZZER is enabled.
OFF : BUZZER is disabled.
PASSWORD:
The PASSWORD option is used to set a 4 digit number password to prevent any unauthorized
re-formatting of the hard disk drives and to use the network viewer.
OLD PASSWORD : Enter the pre-set password (or the standard password if this is the initial
setting) to access the password setting system.
NEW PASSWORD : Enter a 4 digit number password of your choosing which will replace the
pre-set password (or the standard password “9999”).
DEFAULT :
The DEFAULT option is used to reload the factory default setting.
1-19