Filter
Top Products
35
5.5 COMMUNICATION
The COMMUNICATION option is used to configure status of the communication port when the connected
with an external device.
RS232:
The RS232 option is used to determine the activation/ deactivation of the RS232
communication port for externally triggered recording. To record video into the hard-disk drive
connect the REC exposure contact on the rear panel of the DVR to the switch used to activate
the alarm.
MASTER: Sets the KV-HD01A as the master device.
SLAVE: Sets the KV-HD01A as the slave device.
NET ENABLE is used to allow remote users viewing privileges over a network or IP.
OFF: Ethernet capability is turned off
ON: Ethernet capability is turned on
NET SETTING is used to set the IP, MASK, and GATEWAY address of the KV-HD01A.
SET: Sets the IP,MASK, and GATEWAY addresses of the KV-HD01A
MAIN MENU
TIME/ TITLE
RECORD TIMER
RECORD
ALARM
COMMUNICATION
DISK
SYSTEM
GO TO COMM PAGE
COMM SETTING
RS232 : SLAVE
NET ENABLE : OFF
NET SETTING : SET
MAIN PAGE
SET RS232
36
5.6 DISK SETTING
REFORMAT:
The REFORMAT option is used to clear out all of the data in the hard disk drive. You will be
required to enter the pre-set password before proceeding with clearing out the data. Enter the
standard password “9999” if you don’t set your individual password. To set your individual
password, please refer to section 5.7 PASSWORD option.
HD 1 : Deletes all of the data stored in HD 1.
HD 2 : Deletes all of the data stored in HD 2.
HD 3 : Deletes all of the data stored in HD 3.
HD 1 2 : Deletes all of the data stored in HD 1 and HD 2.
HD 1 3 : Deletes all of the data stored in HD 1 and HD 2.
HD 12 3 : Deletes all of the data stored in HD 1, HD 2 and HD 3.
BACKUP HD : Deletes all of the data stored in HD 3, which is set to backup purpose only. (This
function has to be proceeded when the HD 3 USAGE option is set to BACKUP.)
HD 3 USAGE:
The HD 3 USAGE option is used to determine the way to utilize the hard disk drive in the
mobile compartment HD 3.
BACKUP : Used for data backup only, which will not be part of regular recording hard disk
drive.
REC/ PLAY : Used for regular recording hard disk drive.
Note: When you wish to play back a recorded video from HD3, this option must be set to
REC/PLAY.
BACKUP:
The BACKUP option is used to duplicate data from HD 1 and HD 2 to HD 3.
(For operation details, please refer to section 4.5.1)
MAIN MENU
TIME/ TITLE
RECORD TIMER
RECORD
ALARM
COMMUNICATION
DISK
SYSTEM
GO TO DISK PAGE
DISK SETTING
REFORMAT : HD 1
HD 3 USAGE : BACKUP
BACKUP : FULL
DISK REFORMAT/CLEAR
1-18