Filter
Top Products
28
EN
• Wait for several minutes to finish channel
storing.
After Auto Tuning has stopped:
•Use [PROG. / ] or [the Number Buttons] to
change the channel.
• When you use [the Number Buttons], press [0]
first for a single digit number.
•Use [INPUT SELECT ] or [PROG. / ] to
select an external input channel (“AV1”, “AV2” or
“AV3”) of this unit.
To cancel auto tuning:
Press [RETURN] during scanning.
Note
• The selection will be affected by how you receive TV
channels in your local area.
• If the auto tuning is cancelled during scanning,
some channels not yet tuned may not be received.
• You cannot change the channel when either HDD,
DVD or VCR is in any recording mode (normal
recording, One-touch Timer Recording or Timer
Recording).
Manual Tuning
You can tune each channel and set their properties
manually.
1 Press [SETUP] in stop mode.
Setup Menu will appear.
2 Select “Initial Setting” using
[Cursor
U / D], then press [ENTER].
3 Select “Channel Setting” using
[Cursor
U / D], then press [ENTER].
4 Select “Manual Tuning” using
[Cursor
U / D], then press [ENTER].
5 Select the position number of which
you want to change the setting using
[Cursor
U / D], then press [ENTER].
• You can select position numbers 01 to 99.
• You can jump to the next or the previous page
using [SKIP
F] or [SKIP B].
6 Press [Cursor U / D] to start
searching for the available channel.
• Search direction can be switched by pressing
[Cursor
U / D].
• If you already know the channel number, you
can directly enter the channel number using
[the Number buttons]. Refer to the following
Channel Plan table and press the three digits to
select the channel number.
(To select channel 4, press [0] first and then
press [0] and [4]. Or press [4]. And when “4”
appears, wait for 2 seconds.)
• If this is the channel you want, press
[Cursor
P].
Auto Tuning
Auto Tuning Now
Wait for a moment.
Auto Tuning Now
Wait for a moment.
--/--/--(---) --:--
Setup Menu
01/01/07(Mon) 19:34
Disc Management
Editing
Dubbing
Timer Programme
Title List
Initial Setting
Digital Audio Setting
Playback
Recording
Display
Initial Setting
OSD Language
Clock Setting
TV Aspect
Select Video
Video Out
Channel Setting
01/01/07(Mon) 19:34
01/01/07(Mon) 19:34
Initial Setting
OSD Language
Clock Setting
TV Aspect
Select Video
Video Out
Channel Setting
MoveMove
Auto Tuning
Manual Tuning
01/01/07(Mon) 19:34
Manual Tuning
Pos. Channel Decoder Skip Station
P02 45
P03 63
P04 80
P05 88
P06 95
P01 21
P08 2
P07 110
Off
Off
Off
Off
Off
On
Off
Off
Off
Off
Off
Off
Off
Off
On
Off
---
---
---
---
---
ARD
---
---
E3B90ED_EN.book Page 28 Friday, February 23, 2007 12:38 PM