A SERVICE OF

logo

Open as PDF
next previous
20 SPARC Enterprise T5120 and T5220 Servers Installation Guide • August 2007
FIGURE 2-4 Attaching a Mounting Bracket to the Chassis (Either Server)
b. With the heads of the locating pins protruding though the keyed openings
in the mounting bracket, pull the mounting bracket toward the front of the
chassis until the bracket locks into place with an audible click.
c. Verify that all locating pins are trapped in the keyed openings and that the
correct locating pin has engaged the mounting bracket lock, as shown in the
right side of
FIGURE 2-4.
3. Attach the second mounting bracket to the left side of the chassis.
4. Determine which rack hole numbers to use when attaching the slide rails to
the rack posts.
If the SPARC Enterprise T5120 and T5220 is two rack units tall (2U), the slide
rails occupy the lower half of the 2U space.