42 SPARC Enterprise T5120 and T5220 Servers Installation Guide • August 2007
Note – To see these status and error messages, connect a terminal or terminal
emulator to the serial management port (SERIAL MGT). For a basic procedure to
connect a terminal or terminal emulator, see “To Power On the System for the First
Time” on page 43.
For a more detailed discussion on configuring the system console and connecting
terminals, refer to the SPARC Enterprise T5120 and T5220 Server Administration Guide.
ILOM Service Processor
After the system console finishes its low-level system diagnostics, the ILOM service
processor initializes and runs a higher level of diagnostics. When you access the
ILOM service processor using a device connected to the serial management port, you
see the output of the ILOM diagnostics.
By default, the network management port is configured to automatically retrieve
network configuration using Dynamic Host Configuration Protocol (DHCP) and to
allow connections using Secure Shell (SSH).
Note – If you are unable to use DHCP and SSH on your network, you must connect
to the ILOM service processor using the serial management port to reconfigure the
network management port. See “To Configure the Service Processor Network
Management Port” on page 48.
Once the network management port (NET MGT) has been assigned an IP address,
you can connect to the ILOM service processor using SSH.
CLIs, User Accounts, and Passwords for
Connecting to the ILOM Service Processor
When connecting to the ILOM service processor for the first time using the serial or
network management ports, the default CLI is ILOM, the default user account is
root, and the default password is changeme. Examples in this document use the
default ILOM CLI.
ILOM also provides an Advanced Lights Out Management (ALOM) compatability
CLI that uses commands that resemble the ALOM CMT CLI commands. To access
the ALOM compatability CLI, you must first create an admin account with the role
of administrator. Once you create the admin account, assign the ALOM