50 SPARC Enterprise T5120 and T5220 Servers Installation Guide • August 2007
5. If you choose to use a static IP configuration, set the parameters
pendingipdiscovery, pendingipaddress, pendingipgateway, and
pendingipnetmask as follows.
a. Set the service processor to accept a static IP address.
b. Set the IP address for the service processor.
c. Set the IP address for the service processor gateway.
d. Set the netmask for the service processor.
This example uses 255.255.255.0 to set the netmask. Your network environment
subnet might require a different netmask. Use a netmask number most appropriate
to your environment.
6. Use the show /SP/network command to verify that the parameters were set
correctly.
-> set /SP/network pendingipdiscovery=static
Set 'pendingipdiscovery' to 'static'
-> set /SP/network pendingipaddress=service-processor-IPaddr
Set 'pendingipaddress' to 'service-processor-IPaddr'
-> set /SP/network pendingipgateway=gateway-IPaddr
Set 'pendingipgateway' to 'gateway-IPaddr'
-> set /SP/network pendingipnetmask=255.255.255.0
Set 'pendingipnetmask' to '255.255.255.0'
CODE EXAMPLE 3-2 show /SP/network Command Output
-> show /SP/network
/SP/network
Targets:
Properties:
commitpending = (Cannot show property)
dhcp_server_ip = xx.x.xx.x
ipaddress = xx.x.xx.x
ipdiscovery = dhcp
ipgateway = xx.x.xx.x
ipnetmask = 255.255.252.0
macaddress = 00:14:4F:3F:8C:AF
pendingipaddress = xx.x.xx.x
