A SERVICE OF

logo

Open as PDF
next previous
22 SPARC Enterprise T5120 and T5220 Servers Installation Guide • August 2007
c. Loosely attach the rear of the slide rail to the rear rack post with two
screws.
7. Attach the second slide rail to the left rack posts in a similar manner. Do not
tighten the screws.
8. Use the slide rail spacing tool to adjust the distance between the slide rails.
a. At the front of the rack, plug the left side of the tool into slots at the end of
the left rail (
FIGURE 2-6).
FIGURE 2-6 Using the Slide Rail Spacing Tool to Adjust the Distance Between the Slide
Rails (Either Server)
b. Insert the right side of the tool into the front end of the right rail.
c. Slide the end of the rail to the right or left as needed to allow the the ends
of the tool to enter the ends of both rails.
The distance between the rails is now equal to the width of the server with
mounting brackets.