Chapter 2 Installing the SPARC Enterprise T5120 and T5220 Servers 37
FIGURE 2-20 Service Processor Ethernet Network Ports – Rear Panel
1. Connect a Category 5 cable from your network switch or hub to Ethernet Port 0
(NET0) on the rear of the chassis.
NET0 is the farthest left port in the 4-port network cluster in
FIGURE 2-20.
2. Connect Category 5 cables from your network switch or hub to the remaining
Ethernet ports (NET1, NET2, NET3), as needed.
TTYA Serial Port
The TTYA serial port has a DB-9 connector, which is located at the lower right corner
of the rear panel (
FIGURE 2-14). A DB-9 to RJ-45 adapter cable is included in the
shipping kit.
Note – This serial port is not the same as the service processor serial management
port. Use the serial port only for general purpose serial data transfers.
Use a null modem cable or an adapter to perform the crossovers given for each
connector.
USB Ports
Four Universal Serial Bus (USB) ports are provided on the SPARC Enterprise T5120
and T5220. USB ports 0 and 1 are located on the rear panel (
FIGURE 2-14 and
FIGURE 2-16). Ports 2 and 3 are located on the front panel (FIGURE 2-15 and
FIGURE 2-17).
