67
APPENDIX
C
Installing the Servers With the
Express Rail Rackmounting Kit
This appendix provides instructions for installing the servers in an equipment rack
with Express (snap-in) rails. The Express rail rackmounting kit installs quickly and
does not require mounting screws or nuts. The kit and the installation procedures
are the same for both the SPARC Enterprise T5120 and T5220 servers.
Note – If your rackmount kit came with its own instructions, use the instructions in
your rackmount kit instead of the instructions in this appendix. After performing the
server installation, proceed to Chapter 3 for first-time power on.
Note – The procedures in this appendix are the same for both the 1U and 2U
servers. The illustrations show a 2U server only as an example.
This chapter contains the following sections:
■ “Installing the Servers in a Rack With Express Rails” on page 71
■ “Installing the Cable Management Arm” on page 79
■ “Connecting the Server Cables” on page 79
■ “Managing Cables With the CMA” on page 79
■ “Dismounting the Server” on page 79
Note – References to left and right are from your viewpoint as you face either the
front or the rear of the system.
