2-7
Running Diagnostics
Loading and Running the Ram Test
Loading and Running the Ram Test
Your HP/Agilent 8922B comes with software to test the Data Buffer.
Loading the RAM Test
1 Locate the floppy disk labeled “08922-10001, 8922B Driver.”
2 Insert the disk into the drive.
3 Type MSI A: (substitute your drive specifier for A: if your drive is not drive A) and
press .
4 Type LOAD “DRIVER22B”,1 and press .
The Data Buffer Driver will now be loaded and will begin to run.
5 Press
6 Use the cursor to select the output device.
7 Select the area of RAM to test and Press .
8 Repeat selection for each area of RAM.
Where to go next
• If any of the RAM areas tested bad go to chapters 8 and 9.
Selecting from a List
• Use and to scroll through the list. A beep will sound when you reach an end
of the list.
• Use or to move to the first item in the list.
• Use or to move to the last item in the list.
• Use or to select the current item and move to the next field on the
screen.
• Use to select the current item and move to the previous field on the screen.
ENTER
ENTER
K3, "Test RAM
K0, "Accept
⇓
⇓
SHIFT
⇓
PG UP
SHIFT
⇓
PG DOWN
ENTER
⇓
⇓
