Agilent Technologies 8922 VCR User Manual


 
4-3
Using the HP/Agilent 83210A Service Kit
Configuring the RF Extender
Configuring the RF Extender
To extend RF modules, it is necessary to use the RF extender board (08922-60129) with
the correct coax jumper cables. These cables route the RF signals to and from the module
and allow the signal path to be accessed for measurements. The following table and
diagram shows the coax jumpers that are required for each RF module.
Table 4-1 Coax Jumpers for RF Extender Board
Assembly
Number
On PLUG 1 Connect Pin Number On PLUG 3 Connect Pin Numbers
3 7 9 13 17 3 9 13 15 17 20
ForA13 X X X
For A14 X X X X X X
For A15 X X X X X X X X
ForA16 X X X X X X
For A17 X X
For A18 X X X
For A25 X X X
For A26 X X
ForA27 X X X X