Filter
Top Products
Safety
Symbols
To prevent the risk of personal injury or loss related to equipment malfunction, Anritsu Corporation uses the follow-
ing safety symbols to indicate safety-related information. Insure that you clearly understand the meanings of the
symbols
BEFORE
uslng the equipment.
Some or all of the symbols may not be used on this equipment. In addition, when drawings are included in this
manual, labels on the equipment may not be shown on them.
Safety Symbols Used in Manual
This indicates a very dangerous procedure that could result in death or serious
DANGER
A
injury if not performed properly.
This indicates a hazardous procedure that could result in death or serious injury
if
A
not performed properly.
This indicates a hazardous procedure or danger that could result in light-to-severe
A
injury, or loss related to equipment malfunction, if proper precautions are not taken.
Safety Symbols Used on Equipment and/or in Manual
The followmg safety symbols are used inside or on the equipment near operation locations, andlor in manual to
provide information about safety items and operation precautions.
Insure that you clearly understand the
rnean-
ings of the symbols and take the necessary precautions
BEFORE
using the equipment.
This indicates a prohibited operation. The prohibited operation is indicated sym-
bolically in or near the barred circle.
0
This indicates an obligatory safety precaution. The obligatory operation is indi-
cated symbolically in or near the circle.
n
This indicates warning or caution. The contents are indicated symbolically in or
near the triangle.
n
U
This indicates a note. The contents are described in the box
These indicate that the marked part should be recycled.
MP1777A
10
GHz
Jitter Analyzer Remote Control
Operation
Manual
Vol.
2
10 September 1998 (First Edition)
20 September 2002 (Fourth Edition)
Copyright
O
1998-2002, ANRITSU CORPORATION.
All rights reserved. No part of this manual may be reproduced without the prior written permission of the
publisher.
The contents
of
this manual may be changed without prior notice.
Printed in Japan
ii