Anritsu MP1777A Universal Remote User Manual


 
Section
2
GPlB
Interface
2.5
Setting GPlB
To use
GPIB
as
a
remote interface, set the device to the local mode and set the address by performing key input on the
front panel.
Table
2-5
Details
of
Setting when GPlB lnterface is Used
Details of Setting
I
Setting Item
Perform the setting shown above on the Secondary system screen in the hhin setup screen.
Setting Range
Address setting
(1)
(a) Pressing the Setup key causes the Main setup screen to open.
The Main setup screen has "Setup" indicated on the left top section of the screen.
Setu~
I
Interface
1
ITx&Rxl Time
XX
:
XX
:
XX XWXXWXX
Address
Bit
Rate
[
2,488
M
]
Jitter Setting:
Equalizer
[
OFF
]
Clock
[
Internal
]
0
to
30
Fig.
2-3
Main setup Screen
(b) Moving the cursor to the shaded section of the figure above and pressing the Setup key causes a window as
shown below to open. To select the Secondary system screen, move the cursor onto "System" using the cursor
key and press the Set key.
Fig.
2-4
Screen Selection Window