Anritsu MP1777A Universal Remote User Manual


 
8.3
Device-Specific
Commands
8.3
Device-Specif ic
Commands
The following section provides details of the device-specific commands.
As the command descriptions are classified by the subsystem, see the Appendix
D
correspondence between commands
and screens for more information on the correspondence with screens.
Incidentally, the device-specific commands supported by this device are sequential commands with some exceptions
An explanation is glven for commands other than sequential commands every time they come up.
When a set value by a program command causes set values for other items to become unacceptable, they will be changed
to allowed values.
Moreover, the measurement starts again when settings are modified during measurement.
See the details
of
the operation method in this operation manual for conditions to change set values for other items and to
execute restart.
The following section shows examples of descriptions of commands.
<Program
command>
When a restriction on command use exists, an item called the restriction is added to the example below.
Program command
Parameter type (SCPI, device-specific)
I
1
Parameter type (IEEE488.2, SCPI)
I
1
/I
i
:
SENS
:
TEL
:
RANG <port>
-.
Parameter
Function
Example of use
<port>
=
<CHARACTER PROGRAM DATA>
+
;;:
Jitter receiving range
1
UI
Jitter receiving range 4 UI
Selects the range of jitter reception.
Sets the range of jitter reception at UI
4.
>
:
SENS
:
TEL
:
RANG U14
4
I
i
\%
\
Parameter details Example of command use
The right angled blacket
(
>
)
at the header shows that the
segment is a Program mes-
sage and left angled blacket
(
<
)
shows it is a Response.