250
Messages Cause
Adding a
Camera Server
Recording
Schedule
List of Messages
The recording settings of this
camera server have already been
configured in the selected Storage
Server. Check the settings and try
again.
Select a location and zone.
Select a location and zone. ‘Camera
number’
The camera server with the same
host name and port number is being
deleted. Save the changes and add
the server again.
The host name specified in
“Connection Settings” is invalid.
Check the host name or IP address.
The port number specified in
“Connection Settings” is invalid.
Specify a number within the range
of 1 and 65535.
The host name specified in
“Storage Server Configuration” is
invalid. Check the host name or IP
address.
The port number specified in
“Storage Server Configuration” is
invalid. Specify a number within the
range of 1 and 65535.
An error occurred relating to the
schedule change of ‘schedule
name’ for the camera ‘camera
name’ registered in the Storage
Server ‘Storage Server name’. This
change will not be reflected on the
Storage Server side.
Even though video of a camera
server is configured to be recorded in
the Storage Server, the IP address
and port used are the same as the
camera server that has been
configured in the Storage Server.
An attempt was made to add a
camera server without selecting a
location and zone.
An attempt was made to add a
camera server without selecting a
location and zone. This is displayed
when VB150 is in the “simultaneous”
mode and multiple cameras are
connected.
After deleting the camera server, an
attempt was made to add the camera
server again when the changes have
not been saved.
An attempt was made to connect with
an invalid host name/IP address.
An attempt was made to connect with
an invalid port number.
An attempt was made to connect to
the Storage Server with an invalid
host name/IP address.
An attempt was made to connect to
the Storage Server with an invalid
port number.
The destination Storage Server was
not found when you attempted to
save the schedule.